Cisco Nexus 7000 Series Command Reference Manual page 671

S Commands
Command History
Release
6.2(2)
4.0(3)
4.0(1)
Usage Guidelines
This command is not supported for F1 Series modules and F2 Series modules.
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
After using this command, you must enable and disable the interface using the shutdown/no shutdown
command sequence for the configuration to take effect.
This command requires the Advanced Services license.
Examples This example shows how to manually configure Cisco TrustSec SAP on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# cts manual
switch(config-if-cts-manual)# sap pmk fedbaa modelist gmac
switch(config-if-cts-manual)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
This example shows how to remove a manual Cisco TrustSec SAP configuration from an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# cts manual
switch(config-if-cts-manual)# no sap
switch(config-if-cts-manual)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
Related Commands
Command
cts manual
feature cts
show cts interface
Modification
The left-zero-padded, display encrypt and encrypted encrypted_pmk
keywords and argument were added.
The use-dot1x keyword was added.
This command was introduced.
Description
Enters Cisco TrustSec manual configuration mode
for an interface.
Enables the Cisco TrustSec feature.
Displays the Cisco TrustSec configuration for
interfaces.
Cisco Nexus 7000 Series Security Command Reference
sap pmk
645