Cisco ONS 15454 Troubleshooting Manual page 538

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6277 There are no alarm conditions available to run APC Correction
Skipped Override.
EID-6278 APC Correction Skipped Override is not supported for this
card.
EID-6279 Protection cannot be disabled when the FPAS alarm is active.
WID-6280 Any configuration change will be lost and the operation is
traffic affecting.
EID-6281 The port is involved in a protection group.
The protected port is not in the {0} administrative state
WID-6282 Forcing FPGA update will be traffic-affecting.
WID-6283 Enabling ALS on a DWDM trunk port that is connected to a
channel filter
will result in a conflict with the ALS on the amplifier card or
with the
VOA startup process. Is it OK to continue?
WID-6284 Changing the timing standard will re-initialize the shelf timing
and might affect traffic.
OK to continue?
WID-6285 Since you are changing the IP address of one node containing
some PPC terminations,
you are also requested to run the PPC Repair tool in order to fix
the IP addresses stored
in the nodes connected by these PPCs
EID-6286 The port type cannot be changed because the port has been
deleted.
EID-6287 You cannot edit the {0} {1}.
EID-6288 The BERT configuration is invalid.
EID-6289 The BERT mode is not yet configured
WID-6290 The BERT mode is configured in unframed format
WID-6291 Port has circuits; configuring the BERT mode will disrupt
normal traffic.
EID-6292 The alarm type name cannot exceed 20 characters
EID-6294 The alarm type name contains invalid characters.
Only the following characters are valid: 0-9, A-z, a-z and "-".
EID-6295 The alarm type is in use and cannot be deleted.
EID-6296 Maximum number of alarm types that can be added cannot
exceed 50.
EID-6297 Hard coded alarm types cannot be deleted.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-50
Chapter 4
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Change the port state to administrative.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Port rate of Optical and Electrical ports
cannot be changed while circuits are
provisioned on them.
Refer to the eror message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Error Messages
November 2009