Cisco ONS 15454 Troubleshooting Manual page 499

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2147 This is a security violation.
You may only change your own account.
EID-2148 This is a security violation.
You cannot delete the account under which you are currently
logged in.
WID-2149 There is no exportable content in this view.
WID-2150 The node {0} is not initialized.
Please wait and try again.
WID-2152 Spanning tree protection is being disabled for this circuit.
WID-2153 Adding this drop will make the circuit a PCA circuit.
WID-2154 Monitor circuits cannot be created on a port grouping circuit.
WID-2155 Switch counts might not be fully supported on some nodes.
{0}
WID-2156 The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities are in
service and error-free.
WID-2157 The roll(s) cannot be completed.
{0}
EID-2158 The roll mode is invalid.
{0}
EID-2159 The roll is not ready for completion.
{0}
EID-2160 The roll is not connected.
{0}
EID-2161 The sibling roll is not complete.
{0}
EID-2162 An error occurred during roll acknowledgement.
{0}
EID-2163 The roll cannot be canceled.
{0}
EID-2164 An error occurred during the roll.
{0}
November 2009
Description
You cannot change an account other than
your own.
You cannot delete the account you are
currently logged in.
Refer to the error message text.
Wait till the specified node is initialized and
try again.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
The specified nodes do not support switch
counts completely.
Refer to the warning message text.
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one- way
circuit destination roll, the roll mode must
be manual.
The roll is not ready for completion.
Refer to error message text.
One of the rolls is not completed for the
dual roll. If it is auto roll, it will be
completed when a valid signal is detected.
If it is a manual roll, you must complete the
roll from CTC if Bridge and Roll is
operated from CTC, or from TL1 if Bridge
and Roll is operated from TL1.
Refer to the error message text.
CTC cannot cancel the roll.
CTC encountered a roll error.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-11