Cisco ONS 15454 Troubleshooting Manual page 515

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-3271 The value entered must be greater than {0}.
WID-3272 An entry is required.
WID-3273 {0} already exists in the list.
WID-3274 A software upgrade is in progress.
Network configuration changes that result in a node reboot
cannot take place during a software upgrade.
Please try again after the software upgrade is done.
WID-3275 Ensure that the remote interface ID and the local interface ID
on the two sides match.
(The local interface ID on this node should equal the remote
interface ID on the neighbor node and vice-versa).
WID-3276 Both {0} and {1} exist on the same selected port.
{2}
WID-3277 The description cannot exceed {0} characters. Your input will
be truncated.
WID-3279 This card has been deleted. CTC will return to the shelf view.
WID-3280 ALS will not engage until both the protected trunk ports detect
LOS.
WID-3282 Performing a software upgrade while TSC 5 is active could
result in a service disruption. It is recommended that you make
TSC 10 the active TSC by performing a soft reset of TSC 5. The
following ONS 15600s are currently unsafe to upgrade...
WID-3283 Before activating a new version, ensure that you have a
database backup from the current version.
WID-3284 Reverting to an older version.
WID-3285 Applying FORCE or LOCKOUT operations might result in
traffic loss.
WID-3286 The ring status is INCOMPLETE. CTC cannot determine if
there are existing protection operations or switches in other
parts of the ring. Applying a protection operation at this time
could cause a traffic outage. Please confirm that no other
protection operations or switches exist before continuing.
WID-3287 There is a protection operation or protection switch present on
the ring. Applying this protection operation now will probably
cause a traffic outage.
WID-3288 The status of this ring is INCOMPLETE. CTC will not be able
to apply this change to all of the nodes in the {0}.
EID-3290 The specified provisionable patchcord(s) could not be deleted. Refer to the error message text.
November 2009
Description
The value entered must be greater than the
specified value.
An entry is required to complete this task.
The specified item already exists in the list.
Refer to the warning message text.
Refer to the warning message text.
The specified port has both SDCC and
LDCC.
The input exceeds the character limit. The
value will be truncated to the maximum
chapter limit.
CTC returns to node view.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
CTC is being reverted to an older version of
application.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Change the ring status to apply the change
to all nodes in the ring type.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-27