Cisco ONS 15454 Troubleshooting Manual page 466

2.9.4 Physical Card Reseating, Resetting, and Replacement
Caution
The following rules must be followed for removing an Active Cross Connect Card (XC10G/XCVT):
If the active cross connect has to be removed, perform an XCVT/XC10G side switch to change the status
of the card from active to standby and then remove the cross connect card once it goes back to standby.
OR
Perform a lockout on all circuits that originate from the node whose active cross connect card has to be
removed (performing a lockout on all spans will also accomplish the same goal).
2.9.4 Physical Card Reseating, Resetting, and Replacement
This section gives instructions for physically reseating and replacing TCC2/TCC2P, cross-connect, and
traffic cards.
Do not physically replace a card without first making provisions to switch or move traffic to a different
Caution
card or circuit. General procedures for this are located in the
Initiation, and Clearing" section on page
can be found in the "Maintain the Node" chapter of the Cisco ONS 15454 Procedure Guide.
Remove and Reinsert (Reseat) the Standby TCC2/TCC2P Card
Caution Always use the supplied electrostatic discharge wristband when working with a powered ONS 15454.
Plug the wristband cable into the ESD jack located on the lower-right edge of the shelf assembly.
Caution Do not perform this action without the supervision and direction of Cisco TAC 1 800 553-2447.
The TCC2/TCC2P reseat could be service-affecting. Refer to the
Caution
Initiation, and Clearing" section on page 2-262
Before you reset the TCC2/TCC2P, you should wait at least 60 seconds after the last provisioning change
Note
you made to avoid losing any changes to the database.
When a standby TCC2/TCC2P card is removed and reinserted (reseated), all three fan lights could
Note
momentarily turn on, indicating that the fans have also reset.
Step 1 Log into a node on the network.
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-272
Active cross connect (XC10G/XCVT) cards should not be physically removed.
"2.9.2 Protection Switching, Lock
2-262. In-depth traffic switching procedures and information
"2.9.2 Protection Switching, Lock
for traffic-switching procedures.
Chapter 2 Alarm Troubleshooting
November 2009