Cisco ONS 15454 Troubleshooting Manual page 267
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Software feature and configuration manual (232 pages)
Table of Contents
Advertisement
Chapter 2
Alarm Troubleshooting
Clear the CTNEQPT-MISMATCH Condition
Determine what kind of card is preprovisioned in the slot:
Step 1
a.
b.
Step 2
Complete the
If the condition does not clear, log onto http://www.cisco.com/techsupport for more information or call
Step 3
Cisco TAC 1 800 553-2447.
2.7.70 CTNEQPT-PBPROT
The Interconnection Equipment Failure Protect Cross-Connect Card Payload Bus Alarm indicates a
failure of the main payload between the protect ONS 15454 Slot 10 XC10G card and the reporting traffic
card. The cross-connect card and the reporting card are no longer communicating through the backplane.
The problem exists in the cross-connect card and the reporting traffic card, or the TCC2/TCC2P and the
backplane.
This alarm automatically raises and clears when the Slot 8 XC10G card is reseated.
Note
Caution
A software update on a standby TCC2/TCC2P can take up to 30 minutes.
Clear the CTNEQPT-PBPROT Alarm
If all traffic cards show CTNEQPT-PBPROT alarm, complete the following steps:
Step 1
a.
b.
Do not physically reseat an active TCC2/TCC2P. Doing so disrupts traffic.
Caution
November 2009
In node view, click the Inventory tab.
View the information for the slot in the Eqpt Type and Actual Eqpt Type columns.
The Eqpt Type column contains the equipment that is provisioned in the slot. The Actual Eqpt Type
contains the equipment that is physically present in the slot. For example, Slot 8 could be
provisioned for an XCVT card, which is shown in the Eqpt Type column, but an XC10G XC10G
card could be physically present in the slot. The XC10G would be shown in the Actual Eqpt Type
column.
"Physically Replace a Traffic Card" procedure on page 2-273
Default Severity: Critical (CR), Service-Affecting (SA)
SONET Logical Object: EQPT
Complete the
"Remove and Reinsert (Reseat) the Standby TCC2/TCC2P Card" procedure on
page 2-272
for the standby TCC2/TCC2P.
If the reseat fails to clear the alarm, complete the
page 2-273
for the standby TCC2/TCC2P.
2.7.70 CTNEQPT-PBPROT
for the mismatched card.
"Physically Replace a Traffic Card" procedure on
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-73
Advertisement
Table of Contents
