Cisco ONS 15454 Troubleshooting Manual page 516

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3291 The revertive behavior cannot be changed because a protection
switch is active.
EID-3292 An error occurred while resetting the shelf.
EID-3293 No such provisionable patchcords exists.
EID-3294 No RMON thresholds are available for the selected port.
EID-3295 This card does not support RMON thresholds.
EID-3296 Buffer-to-buffer credit is only supported for Fibre Channel (FC)
and FICON.
EID-3298 This interfaces does not support ALS auto restart.
EID-3300 Duplicate OSPF area IDs are not permitted.
EID-3301 The LAN metric cannot be zero.
EID-3302 The standby {0} is not ready.
EID-3303 The DCC area ID and {0} conflict.
{1}
EID-3304 The DCC number is out of range.
EID-3305 OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface.
EID-3306 Ethernet circuits must be bidirectional.
EID-3307 An error occurred while creating a connection object at {0}.
EID-3308 DWDM links can be used only for optical channel circuits.
EID-3309 The link was excluded because it was in the wrong direction.
EID-3310 The DWDM link does not have wavelengths available.
EID-3311 The laser is already on.
EID-3312 The power setpoint cannot be changed.
{0} {1}
EID-3313 The offset cannot be modified because the service state of the
port is IS.
EID-3314 The requested action is not allowed.
The state value is invalid.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-28
Chapter 4
Description
Protection switch should not be active to
change the revertive behavior.
CTC encountered an error while resetting
the node.
You are attempting to delete a provisionable
patchcord that does not exist. This happens
when multiple instances of CTC are
running and attempting to delete the same
provisionable patchcord concurrently.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
OSPF area IDs should be unique.
Refer to the error message text.
Standby controller card is not ready.
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
Enter a DCC number that is within the range
You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
Refer to the error message text.
CTC encountered an error at the specified
connection while creating the connection.
Refer to the error message text.
The optical channel (circuit) does not allow
the specified link to be included because it
is in the wrong optical direction.
Refer to the error message text.
Refer to the error message text.
CTC cannot change the power setpoint. The
new setpoint would either make the
thresholds inconsistent or set the fail
threshold outside the range.
Refer to the error message text.
Refer to the error message text.
Error Messages
November 2009