Cisco ONS 15454 Troubleshooting Manual page 507

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3078 An optical link could not be created.
EID-3079 Defaults cannot be applied to the node. {0}
EID-3080 CTC cannot navigate to the target tab.
{0}
EID-3081 The port type cannot be changed.
EID-3082 The {0} extension byte cannot be changed.
EID-3084 An error occurred while retrieving laser parameters for {0}.
EID-3085 No OSC Terminations were selected
EID-3086 One or more Osc terminations could not be created.
EID-3087 The OSC termination could not be edited.
EID-3088 No {0} card is present to switch.
EID-3089 The {0} state cannot be used or changed when the {1} has
failed or is missing.
EID-3090 The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
EID-3091 The operation cannot be performed because the protect card is
active.
EID-3092 The requested action cannot be applied because the service
state is invalid.
EID-3093 The operation cannot be performed because the duplex pair is
{0}locked.
EID-3094 The operation cannot be performed because no cross-connect
redundancy is available.
EID-3095 The deletion failed because the circuit is in use
WID-3096 An internal communication error was encountered while
retrieving laser parameters.
This can happen when equipment is not present or when
equipment is resetting.
Check the equipment state and try to refresh the values again.
EID-3097 The ring termination is in use.
EID-3098 No ring terminations were selected.
EID-3099 The entered key does not match the existing authentication key. Check the authentication key and reenter.
November 2009
Description
Refer to the error message text.
CTC cannot apply the defaults to the
specified node.
CTC cannot go to the specified target tab.
Refer to the error message text.
You cannot modify the specified extension
byte.
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
Select an OSC termination and proceed.
Refer to the error message text.
Refer to the error message text.
No card of the specified type is available to
switch.
You cannot use or change the specified state
when the card is failed or missing.
You cannot perform operation.
Refer to the error message text.
Select another service state and proceed.
Refer to the error message text.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
Refer to the error message text.
Refer to the warning message text.
The ring termination you are trying to
access is in use. Try after sometime.
Select one of the ring terminations.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-19