Cisco ONS 15454 Troubleshooting Manual page 493

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2018 The circuit roll failed.
The circuit must be in the DISCOVERED state in order to
perform a roll.
EID-2019 The circuit roll failed.
Bridge and roll is not supported on DWDM circuits.
EID-2020 The circuit roll failed.
The two circuits must have the same direction.
EID-2021 The circuit roll failed.
The two circuits must have the same size.
EID-2022 The circuit roll failed.
A maximum of two circuits can be selected for a bridge and roll
operation.
EID-2023 CTC was unable to create a new user account.
EID-2024 An error occurred during node selection.
EID-2025 This feature cannot be used. Verify that each endpoint of this
circuit is running software that supports this feature.
EID-2026 The {0} request could not be applied.
{1}
EID-2027 An error occurred while deleting the circuit drop.
EID-2028 An error occurred while removing the circuit node.
EID-2029 The requested operation is not supported.
EID-2030 An error occurred during provisioning.
EID-2031 An error occurred while adding the node.
EID-2032 The circuit could not be renamed.
{0}
EID-2033 An error occurred during validation.
{0}
EID-2034 Network circuits could not be added:
{0}
EID-2035 The source and destination nodes are not connected.
November 2009
Description
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There was an error during node selection.
Refer to the error or warning message text.
For example, this error is generated from
the node view Provisioning> WDM-ANS>
tabs to indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card view
(Ethernet card only), where it indicates that
the back-end spanning tree protocol (STP)
disabling is not supported.
Error occurred while attempting to switch a
path protection.
CTC could not delete the circuit drop.
CTC could not remove the circuit node.
The task you are trying to complete is not
supported by CTC.
There was an error during provisioning.
There was an error while adding a node.
CTC could not rename the circuit.
There was an internal error while validating
the user changes after the Apply button was
pressed. This error can occur in the Edit
Circuit dialog box or in the BLSR table in
the shelf view (rare condition).
Refer to the error message text.
Refer to the error message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-5