Cisco ONS 15454 Troubleshooting Manual page 504

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2331 Deleting {0} might be service affecting.
EID-2332 A validation error occurred in row {0}.
{1} hold-off timer for {2} must be between {3}-10,000 ms, in
steps of 100 ms.
EID-3001 An Ethernet RMON threshold with the same parameters
already exists. Please change one or more of the parameters and
try again.
EID-3002 An error occurred while retrieving defaults from the node: {0} There was an error while retrieving the
EID-3003 The file {0} cannot be loaded.
EID-3004 Properties cannot be loaded from the node.
EID-3005 NE update properties cannot be saved to the file {0}.
EID-3006 NE update properties cannot be loaded from the node.
EID-3007 An error occurred while provisioning the {0}.
EID-3008 This is not a valid card.
EID-3009 No {0} was selected.
EID-3010 A bidirectional optical link could not be created.
EID-3016 The subnet address is invalid.
EID-3017 The subnet address already exists.
EID-3019 The internal subnet address is incomplete.
EID-3020 The subnet address cannot be the same for both TSC cards.
The requested action is not allowed.
EID-3021 An error occurred while retrieving the diagnostics:
{0}
EID-3022 The requested action is not allowed.
EID-3023 The low order cross-connect mode could not be retrieved.
EID-3024 The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
EID-3025 An error occurred while retrieving thresholds.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-16
Chapter 4
Description
Deleting the item can affect the service of
CTC.
Refer to the error message text.
Change a few parameters in an Ethernet
remote monitoring (RMON) threshold and
try again.
defaults from the specified node.
CTC cannot load the specified file.
Refer to the error message text.
CTC cannot save the network element (NE)
update values to the specified file.
Refer to the error message text.
There was a provisioning error for the
specified item.
You cannot perform DWDM automatic
node setup (ANS) from the Card view.
Please navigate to the Node view and try
again.
Select the specified item, for example,
VLAN, port, slot, etc.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Enter the complete internal subnet address.
A node's internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
Refer to the error message text.
The requested action is not allowed.
Refer to the error message text.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
There was an error retrieving the thresholds.
Error Messages
November 2009