Cisco ONS 15454 Troubleshooting Manual page 248

2.7.36 AUTOSW-SFBER
Clear the AUTOSW-SDBER Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.36 AUTOSW-SFBER
The Automatic USPR Switch Caused by Signal Fail Bit Error Rate (SFBER) condition indicates that a
"SF-P" condition on page 2-224
protection is configured for revertive switching, the path protection reverts to the working path when the
SF-P is resolved.
Note This condition is only reported if the path protection is set up for revertive switching.
Clear the AUTOSW-SFBER Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.37 AUTOSW-UNEQ (STSMON)
The Automatic Path Protection Switch Caused by Unequipped condition indicates that an
alarm on page
configured for revertive switching, it reverts to the working path after the fault clears.
Note This condition is only reported if the path protection is set up for revertive switching.
Clear the AUTOSW-UNEQ (STSMON) Condition
Complete the
Step 1
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-54
"Clear the SD-P Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
"Clear the SF-P Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: STSMON
2-252, caused automatic path protection switching to occur. If the path protection is
"Clear the UNEQ-P Alarm" procedure on page
caused automatic path protection switching to occur. If the path
Chapter 2 Alarm Troubleshooting
2-221.
2-224.
2-252.
"UNEQ-P"
November 2009