Cisco ONS 15454 Troubleshooting Manual page 382
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Software feature and configuration manual (232 pages)
Table of Contents
Advertisement
2.7.284 NON-CISCO-PPM
Follow the card provisioning instructions in the Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet
Card Software Feature and Configuration Guide.
Upload the configuration file to the TCC2/TCC2P:
Step 2
a.
b.
c.
Complete the
Step 3
If the condition does not clear, log into the Technical Support Website at
Step 4
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.284 NON-CISCO-PPM
The Non-Cisco PPM Inserted condition occurs when a PPM that is plugged into a card's port fails the
security code check. The check fails when the PPM used is not a Cisco PPM.
Clear the NON-CISCO-PPM Condition
Obtain the correct Cisco PPM and replace the existing PPM with the new one.
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.285 NOT-AUTHENTICATED
The NOT-AUTHENTICATED alarm is raised by CTC (not by the NE) when CTC fails to log into a node.
This alarm only appears in CTC where the login failure occurred. This alarm differs from the
"INTRUSION-PSWD" alarm on page 2-131
the login failures threshold.
Note
NOT-AUTHENTICATED is an informational alarm and is resolved when CTC successfully logs into the
node.
2.7.286 OCHNC-INC
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-188
In node view, right-click the ML-Series card graphic.
Choose IOS Startup Config from the shortcut menu.
Click Local > TCC and navigate to the file location.
"Reset a Traffic Card in CTC" procedure on page
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
SONET Logical Object: PPM
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: SYSTEM
2-270.
because INTRUSION-PSWD occurs when a user exceeds
Chapter 2
Alarm Troubleshooting
November 2009
Advertisement
Table of Contents
