Cisco ONS 15454 Troubleshooting Manual page 536

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6226 Invalid buffer size value
EID-6227 Invalid egress QOS value
EID-6228 Invalid QinQ working Mode
EID-6229 Configured protection status Not Supported
EID-6230 The number of provisioned entries exceeds the limit
EID-6231 This is not a valid VLAN ID.
EID-6232 The VLAN remapping ID is not allowed.
EID-6233 The CVLAN is duplicated.
EID-6234 The VLAN ID is out of range.
EID-6235 This is not a valid VLAN name.
EID-6236 The protected VLAN number exceeds the maximum allowed.
EID-6237 The port is not in OOS disabled admin state
EID-6238 The VLAN ID is in use.
EID-6239 APC wrong node side.
EID-6240 You cannot change the Admin State for an interlink port when
it is part of an ADM peer group. This operation is not
supported.
EID-6242 The protection slot is invalid.
EID-6243 The {0} address of {1} is invalid.
EID-6244 The mask of {0} is invalid.
EID-6245 The cost must be between 1 and 32767.
EID-6246 The {0} address cannot be {1}.
EID-6247 The authentication type is invalid.
EID-6248 The cost must between 1 and 15.
EID-6249 The port has a cross-connect.
EID-6250 The reversion time is invalid.
EID-6251 Invalid Margin For Span Aging.
Value is not in the range 0 - 10.
EID-6252 The data cannot be retrieved because ANS parameters cannot
be calculated on the node in its current configuration.
EID-6253 Invalid Margin For Span Aging.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-48
Chapter 4
Description
The Buffer size value is invalid. Enter
again.
The egress QOS value is invalid. Enter
again.
The QinQ working mode is invalid. Enter
again.
The protection status is not supported
Refer to the error message text.
Entered VLAN ID is not present in the
database file.
Refer to the error message text.
You cannot have identical CVLAN IDs.
The VLAN ID entered is out of range.
The entered VLAN name exceeds the
number of characters (32) allowed.
The user enters more than 256 protected
VLAN in the VLAN database.
Refer to the error message text.
The entered VLAN ID is in use by a node.
Refer to the error message text.
Refer to the error message text.
You must select a valid protection slot.
Refer to the error message text.
The mask of the specified value is not valid.
Refer to the error message text.
Refer to the error message text.
Enter a valid authentication type.
Refer to the error message text.
Refer to the error message text.
The reversion time is invalid. Enter again.
Enter a value between 0 and 10.
Refer to the error message text.
Refer to the error message text.
Error Messages
November 2009