Cisco ONS 15454 Troubleshooting Manual page 123

Chapter 1 General Troubleshooting
Create a Facility Loopback on an Intermediate-Node Ethernet Port
Connect an optical test set to the port you are testing:
Step 1
Note
a.
b.
Adjust the test set accordingly. (Refer to manufacturer instructions for test-set use.)
Step 2
Use CTC to set up the facility loopback on the test port:
Step 3
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Confirm that the newly created circuit appears on the Circuits tab list as a two-way circuit.
Step 4
Note
Create the facility loopback on the destination port being tested:
Step 5
a.
b.
c.
November 2009
For specific procedures to connect, set up, and use the test set equipment, consult the
manufacturer.
If you just completed the
procedure on page 1-71, leave the optical test set hooked up to the source-node port.
If you are starting the current procedure without the optical test set hooked up to the source port
port, use appropriate cabling to attach the Tx and Rx terminals of the optical test set to the port you
are testing. Both Tx and Rx connect to the same port.
In node view, click the Circuits tab and click Create.
In the Circuit Creation dialog box, choose the type, such as STS, and number, such as 1.
Click Next.
In the next Circuit Creation dialog box, give the circuit an easily identifiable name such as
G1KtoG1K3.
Leave the Bidirectional check box checked.
Click Next.
In the Circuit Creation source dialog box, select the same Node, card Slot, Port, and STS (or VT)
where the test set is connected.
Click Next.
In the Circuit Creation destination dialog box, use the same Node, card Slot, Port, and STS (or VT)
used for the source dialog box.
Click Next.
In the Circuit Creation circuit routing preferences dialog box, leave all defaults. Click Finish.
It is normal for the "LPBKFACILITY (G1000)" condition on page 2-172
"CLPBKFACILITY (OCN)" condition on page 2-172
condition clears when you remove the loopback.
Go to the node view of the intermediate node:
Choose View > Go To Other Node from the menu bar.
•
• Choose the node from the drop-down list in the Select Node dialog box and click OK.
In node view, double-click the intermediate-node card that requires the loopback.
Click the Maintenance > Loopback tabs.
1.5.4 Create a Facility Loopback on an Intermediate-Node Ethernet Port
"1.5.2 Perform a Terminal Loopback on a Source-Node Ethernet Port"
Cisco ONS 15454 Troubleshooting Guide, R8.5
or the
to appear during a loopback setup. The
1-79