Cisco ONS 15454 Troubleshooting Manual page 531

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-6085 Disabling shell access will prevent Cisco TAC from connecting
to the vxWorks shell to assist users.
EID-6086 The card cannot be changed because card resources are in use. The card you are trying to remove is being
EID-6087 The card cannot be changed because the card type is invalid or
incompatible.
EID-6088 This line cannot be put into loopback while it is in use as a
timing source.
EID-6089 The interface was not found. {0}
EID-6090 The interface type is not valid for this operation. {0}
EID-6091 The current state of the interface prohibits this operation. {0}
EID-6092 This operation is prohibited for this interface. {0}
EID-6093 The maximum number of TARP data cache entries has been
exceeded.
EID-6094 The maximum number of manual adjacency table entries has
been exceeded.
EID-6095 The AIS/Squelch mode is invalid.
EID-6096 A default IP-over-CLNS tunnel route is only allowed on a node
without a default static route and a default router of 0.0.0.0.
EID-6097 The authorization key does not comply with Cisco IOS
password restrictions.
{0}
EID-6098 A default static route is not allowed when a default
IP-over-CLNS tunnel exists.
EID-6099 You cannot create a subnet on a disabled router.
WID-6100 Disabling a router that has a provisioned subnet is not
recommended.
EID-6101 The MAT entry already exists.
WID-6102 The new card has less bandwidth than the current card. Circuits
of size VT15 and larger will be deleted.
EID-6103 The TDC entry already exists.
EID-6104 APC ABORTED.
EID-6105 The 'Change Card' command is valid for MRC cards only when
Port 1 is the sole provisioned port.
EID-6106 To delete all RADIUS server entries, RADIUS authentication
must be disabled.
November 2009
Description
Refer to the warning message text.
used. Cannot change the card.
Refer to the error message text.
Refer to the error message text.
CTC cannot find the specified interface.
Choose another interface.
The port is in an invalid state to set a
loopback.
CTC does not allow this operation for the
specified interface.
You have exceeded the number of
characters permitted.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Specify another authorization key.
Refer to the error message text.
Create the subnet on an active router.
Refer to the warning message text.
Refer to the error message text.
Refer to the warning message text.
Specify another entry for TARP Data
Cache.
Automatic Power Control is aborted.
Refer to the error message text.
Disable Radius authentication and proceed.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-43