Cisco ONS 15454 Troubleshooting Manual page 478

2.9.7 Interface Procedures
Step 20 Record the new MAC address:
In node view, click the Provisioning > Network > General tabs.
a.
Record the MAC address.
b.
In node view, click the Circuits tab. Note that all circuits listed are PARTIAL.
Step 21
In node view, choose Repair Circuits from the Tools drop-down list. The Circuit Repair dialog box
Step 22
appears.
Read the instructions in the Circuit Repair dialog box. If all the steps in the dialog box have been
Step 23
completed, click Next. Ensure that you have the old and new MAC addresses.
Step 24 The Node MAC Addresses dialog box appears. Complete the following steps:
From the Node drop-down list, choose the name of the node where you replaced the AIP.
a.
In the Old MAC Address field, enter the old MAC address that was recorded in
b.
Click Next.
c.
The Repair Circuits dialog box appears. Read the information in the dialog box and click Finish.
Step 25
The CTC session freezes until all circuits are repaired. Circuit repair can take up to five minutes or more
depending on the number of circuits provisioned on it.
When the circuit repair is complete, the Circuits Repaired dialog box appears.
Click OK.
Step 26
In the node view of the new node, click the Circuits tab. Note that all circuits listed are DISCOVERED.
Step 27
If all circuits listed do not have a DISCOVERED status, call the Cisco TAC 1 800 553-2447 to open a
Return Material Authorization (RMA).
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-284
Chapter 2 Alarm Troubleshooting
Step 2.
November 2009