Cisco ONS 15454 Troubleshooting Manual page 513

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3235 The requested state transition cannot be performed on this
software version.
EID-3236 The database restore failed. {0}
EID-3237 The database backup failed. {0}
EID-3238 The send PDIP setting on {0} is inconsistent with the setting on
the control node {1}.
EID-3239 The overhead termination is invalid
EID-3240 The maximum number of overhead terminations has been
exceeded.
EID-3241 The {0} termination port is in use.
EID-3242 An {1} exists on the selected ports.
Therefore, you must create the {0}s one by one.
WID-3243 The port you have chosen as an {0} endpoint already supports
an {1}. The port cannot support both DCCs. After the {0} is
created, verify that no EOC alarms are present and then delete
the {1} to complete the downgrade.
EID-3244 An {0} exists on the selected ports.
Therefore, you must create the {1}s one by one.
WID-3245 The port you have chosen as an {1} endpoint already supports
an {0}. The port cannot support both DCCs. After the {1} is
created, verify that no EOC alarms are present and then delete
the {0} to complete the upgrade.
EID-3246 The wizard was not able to validate the data.
{0}
EID-3247 An ordering error occurred. The absolute value should be {0}. The absolute value entered was wrong.
EID-3248 The value for the parameter {0} is invalid.
EID-3249 The voltage increment value is invalid.
EID-3250 The power monitor range is invalid.
EID-3251 The requested action could not be completed.
{0}
EID-3252 No download has been initiated from this CTC session.
EID-3253 The reboot operation failed. {0}
November 2009
Description
Refer to the error message text.
CTC failed to restore the specified
database.
CTC failed to backup the specified
database.
The send payload defect indicator path
(PDI-P) setting on the specified item should
be consistent with that of the specified
control node.
Refer to the error message text.
Overhead terminations have exceeded the
limit.
The specified termination port is in use.
Select another port.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The same port can not be used by multiple
DCCs.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The port selected as a DCC endpoint
already supports another DCC. Refer to the
warning message text.
CTC encountered an error.
CTC changed the incorrect parameter.
Refer to the error message text.
Refer to the error message text.
CTC could not complete the specified
action.
Refer to the error message text.
Refer to the error message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-25