Cisco ONS 15454 Troubleshooting Manual page 216

2.4 Alarm List by Logical Object Type
Table 2-7
Logical Object
PPM
PWR
RPRIF
SHELF
STSMON
STSTRM
TLINK
TRUNK
VCG
VT-MON
VT-TERM
2.4 Alarm List by Logical Object Type
Table 2-8
The list entries are organized by logical object name and then by alarm or condition name. Where
appropriate, the alarm entries also contain troubleshooting procedures.
Note In a mixed network containing different types of nodes (such as ONS 15310-CL, ONS 15454, and
ONS 15600), the initially displayed alarm list in the Provisioning > Alarm Profiles > Alarm Profile
Editor tab lists all conditions that are applicable to all nodes in the network. However, when you load
the default severity profile from a node, only applicable alarms will display severity levels.
Nonapplicable alarms can display "use default" or "unset."
In some cases this list does not follow alphabetical order, but it does reflect the order shown in CTC.
Note
Table 2-8 Alarm List by Logical Object in Alarm Profile
2R: ALS (NA)
2R: AS-CMD (NA)
2R: AS-MT (NA)
2R: FAILTOSW (NA)
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-22
Alarm Logical Object Type Definitions (continued)
Definition
Pluggable port module (PPM), referring to OC192-XFP, MXP, TXP, and MRC
cards. For more information about PPM alarms, refer to the "Alarm
Troubleshooting" chapter in the Cisco ONS 15454 DWDM Troubleshooting Guide.
Power equipment.
Interface for Resilient Packet Ring technology as defined in IEEE 802.17b. Also
called RPR-IEEE.
The shelf assembly. For more information about most of the alarms on this object,
refer to the "Alarm Troubleshooting" chapter of the Cisco ONS 15454 DWDM
Troubleshooting Guide.
STS alarm detection at the monitor point (upstream from the cross-connect).
STS alarm detection at termination (downstream from the cross-connect).
Traffic engineering (TE) link correlation.
The optical or DWDM card carrying the high-speed signal; referring to MXP or
TXP cards. For more information about TRUNK alarms, refer to the "Alarm
Troubleshooting" chapter in the Cisco ONS 15454 DWDM Troubleshooting Guide.
A virtual concatenation group of VTs.
VT1 alarm detection at the monitor point (upstream from the cross-connect).
VT1 alarm detection at termination (downstream from the cross-connect).
lists all ONS 15454 alarms and logical objects as they are given in the system alarm profile.
FC: AS-CMD (NA)
FC: AS-MT (NA)
FC: CARLOSS (MJ)
FC: FAILTOSW (NA)
Chapter 2 Alarm Troubleshooting
OCN: MANUAL-REQ-RING (NA)
OCN: MANUAL-REQ-SPAN (NA)
OCN: PRC-DUPID (MJ)
OCN: RFI-L (NR)
November 2009