Cisco ONS 15454 Troubleshooting Manual page 512

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3188 An error occurred during authentication. The password entered
is invalid.
EID-3189 The sum of the {0} must be between {1} and {2}.
EID-3214 The number of high order circuits for the line could not be
retrieved.
EID-3215 An error occurred while refreshing.
EID-3216 The proxy port is invalid.
EID-3217 The statistics could not be refreshed.
EID-3218 The automatic node setup could not be launched.
EID-3219 The automatic node setup information could not be refreshed.
EID-3220 An error occurred while refreshing row {0}.
EID-3222 The statistics could not be cleared.
EID-3225 An error occurred while refreshing the pane.
EID-3226 The {0} termination(s) could not be deleted.
{1}
EID-3227 A baseline could not be recorded. Performance metrics will
remain unchanged.
EID-3228 The {0} termination(s) could not be created.
{1}
EID-3229 RIP is active on the LAN. Please disable RIP before enabling
OSPF.
EID-3230 OSPF is active on the LAN. Please disable OSPF before
enabling RIP.
EID-3231 An error occurred while setting the OPR.
WID-3232 The port state cannot be indirectly transitioned because the port
is still providing services.
If the port state should be changed, edit it directly through port
provisioning.
EID-3233 The current loopback provisioning does not allow this state
transition.
EID-3234 The current synchronization provisioning does not allow this
state transition.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-24
Chapter 4
Description
The password you entered is invalid. Enter
the password again.
Refer to the error message text.
The number of High Orders (STS/STM) for
the line is not available.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC could not refresh statistics values.
Refer to the error message text.
Failure trying to retrieve automatic node
setup information.
Error refreshing the specified row.
Refer to the error message text.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC failed to set the baseline values while
provisioning NE. Previous values remain
unchanged.
Refer to the error message text.
Turn off the Routing Information Protocol
(RIP) on the LAN, before enabling OSPF.
Turn off the OSPF on the LAN before
enabling RIP.
An error was encountered while attempting
to provision the optical power received
(OPR).
Edit the port state while provisioning the
port.
Refer to the error message text.
You cannot transition the port state to the
target date while in the current
synchronization state.
Error Messages
November 2009