Cisco ONS 15454 Troubleshooting Manual page 527

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-5091 Some PPC terminations were not repaired.
WID-5092 The TL1 encoding mode for the tunnel is being changed.
Do you want to modify the encoding?
EID-6000 This platform does not support power monitoring thresholds.
EID-6001 One of the XC cards has failures or is missing.
EID-6002 One of the XC cards is locked.
EID-6003 The OSC termination could not be created.
This ring ID is already assigned.
EID-6004 A system reset cannot be performed while a BLSR ring is
provisioned on the node.
EID-6005 The timing references could not be assigned.
- Only two DS1 or BITS interfaces can be specified.
- DS1 interfaces cannot be retimed and used as a reference.
- BITS-2 is not supported on this platform.
EID-6006 The timing references could not be assigned.
- An NE reference can only be used if the timing mode is LINE.
- A BITS reference can only be used if the timing mode is not
LINE.
- A Line reference can only be used if the timing mode is not
EXTERNAL.
EID-6008 SF BER and SD BER are not provisionable on the protect line
of a protection group.
WID-6009 If autoadjust GFP buffers is disabled, GFP buffers available
must be set to an appropriate value based on the distance
between the circuit endpoints.
WID-6010 If auto detection of credits is disabled, credits available must be
set to a value less than or equal to the number of receive credits
on the connected FC endpoint.
WID-6011 Ingress idle filtering should be turned off only when required to
operate with non-Cisco Fibre Channel/FICON-over-SONET
equipment.
EID-6012 The retiming configuration could not be changed because there
are circuits on this port.
EID-6013 The NTP/SNTP server could not be changed.
{1}
EID-6014 The operation failed because the reference state is OOS.
EID-6015 The distance extension cannot be disabled if the port media type
is FICON 1Gbps ISL or FICON 2Gbps ISL.
November 2009
Description
Refer to the error message text
Confirm if you really want to modify TL1
tunnel encoding.
Refer to the error message text.
Check whether all the cross-connect cards
are installed and working.
Unlock the cross-connect card.
Enter a new ID for the ring.
Remove the BLSR from the node and
continue with the reset procedure.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
You cannot change the timing configuration
on this port unless the circuits on this port
are deleted.
Refer to the error message text.
Change the Out-of-service state to Active.
Refer to the error message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-39