Cisco ONS 15454 Troubleshooting Manual page 530

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6063 The selected router does not exist.
EID-6064 The MAA address list is full.
EID-6065 The selected area address is duplicated.
EID-6066 The primary area address cannot be removed.
EID-6067 The selected area address does not exist.
EID-6068 The IP-over-CLNS NSEL cannot be modified while there are
IP-over-CLNS tunnel routes provisioned.
EID-6069 The node is currently in ES mode. Only Router 1 can be
provisioned.
EID-6070 No router was selected.
EID-6071 The TARP data cache cannot be flushed.
EID-6072 The TARP data cache entry cannot be added:
{0}
WID-6073 A TARP request has been initiated.
Try refreshing the TARP data cache later.
EID-6074 End system mode only supports one subnet.
EID-6075 An error occurred while trying to remove a MAT entry. The
entry does not exist.
EID-6076 An error occurred while trying to {0} a TARP manual
adjacency entry:
{1}
EID-6077 The area address must be between 1 and 13 bytes long,
inclusive.
EID-6078 A TDC entry with this TID {0} does not exist in the table.
EID-6079 A TDC entry with this TID {0} could not be removed.
Please verify that TARP is enabled.
WID-6080 Router {0} does not have an area address in common with
Router 1. Switching from IS L1/L2 to IS L1 in this case will
partition your network.
EID-6081 The limit of 10 RADIUS server entries has been reached.
EID-6082 {0} cannot be empty.
EID-6083 The entry you selected for editing has been altered by another
user. The changes cannot be committed.
EID-6084 The RADIUS server entry already exists.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-42
Chapter 4
Description
Create a router.
Refer to the error message text.
Enter another area address.
Refer to the error message text.
Choose another area address.
You cannot change the NSEL address if
tunnels are provisioned.
An End System needs only one provisioned
router.
Select a router.
You cannot flush the cache in the Tunnel
identifier Address Resolution Protocol
(TARP) state.
You cannot add the specified cache entry.
Refer to the warning message text.
Refer to the error message text.
CTC is removing the MAT entry.
CTC cannot add the specified adjacency
entry for reasons unknown.
The area address should not be more than 13
characters.
The specified Tunnel Identifier does not
exist.
You must enable TARP to remove the TDC
entry.
Refer to the warning message text.
CTC does not allow more than 10 RADIUS
servers.
The Shared Secrets field should not be
empty.
Refer to the error message text.
Specify another RADIUS server entry.
Error Messages
November 2009