Cisco ONS 15454 Troubleshooting Manual page 494

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2036 The {0} cannot be deleted.
LAN Access has been disabled on this node and this {0} is
needed to access the node.
EID-2037 The attribute for {0} cannot be found.
EID-2038 The protection operation is invalid.
EID-2040 Please select a node first.
EID-2041 No paths are available on this link. Please make another
selection.
EID-2042 This span is not selectable. Only the green spans with an arrow
may be selected.
EID-2043 This node is not selectable. Only the source node and nodes
attached to included spans (blue) are selectable. Selecting a
selectable node will enable its available outgoing spans.
EID-2044 This link may not be included in the required list. Constraints
only apply to the primary path. Each node may have a
maximum of one incoming signal and one outgoing link.
EID-2045 This link may not be included in the required list. Only one
outgoing link may be included for each node.
EID-2047 Please enter a valid value for the slot number.
EID-2048 Please enter a valid value for the port number.
EID-2050 The new circuit could not be destroyed.
EID-2051 The circuit cannot be downgraded.
{0}
EID-2052 An error occurred during circuit processing.
EID-2054 An error occurred while selecting an endpoint.
EID-2055 No endpoints are available for this selection. Please make
another selection.
EID-2056 A communication error occurred: {0}
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-6
Chapter 4
Description
You cannot delete the DCC/GCC link as it
is needed to access the node.
CTC cannot find an attribute for the
specified item.
The protection operation you tried to
execute is invalid.
You must select a node before performing
the task.
You must select a link that has paths
available.
Refer to the error message text.
Refer to the error message text.
You must select only one link going in and
out of a node. Selecting more than one link
is contradictory to the path selection
algorithm.
Refer to the error message text.
There was an error due to an invalid slot
number.
There was an error due to an invalid port
number.
CTC could not destroy the new circuit.
The specified circuit cannot be
downgraded.
There was an error during the circuit
processing.
There was an error during the endpoint
selection.
This error occurs in the circuit creation
dialog only during a race condition that has
incorrectly allowed entities without
endpoints to be displayed in the
combination boxes.
An internal error occurred in Network
Alarm tab while synchronizing alarms with
the nodes.
Error Messages
November 2009