Cisco ONS 15454 Troubleshooting Manual page 503

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2221 A valid route cannot be found for the unprotected to {0}
upgrade request.
EID-2222 One or more of the following nodes are currently part of a
four-fiber {0}. Only a single four-fiber {0} is supported per
node.
{1}
EID-2223 Only one circuit can be upgraded at a time.
EID-2224 This link may not be included because it terminates on the
source.
EID-2225 A valid signal could not be detected while trying to complete
the roll.
{0}
EID-2226 The circuit roll failed.
{0}
EID-2320 This VCAT circuit does not support deletion of its member
circuits.
EID-2321 An error occurred while deleting member circuits.
{0}
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They might appear as partial circuits.
EID-2323 The circuit roll failed.
Bridge and roll is not supported on monitor circuits.
EID-2324 An error occurred during the circuit upgrade.
{0}
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box.
WID-2326 Currently, CTC does not support bridge and roll on circuits that
are entirely created by TL1. To continue with bridge and roll in
CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
WID-2327 Currently, CTC does not support bridge and roll on circuits that
are partially created by TL1. To continue with bridge and roll
in CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
EID-2328 An error occurred during the circuit reconfiguration.
{0}
EID-2329 {0} of {1} circuits could not be successfully created.
EID-2330 An error occurred during circuit verification. The selected {0}
is invalid!
{1}
November 2009
Description
Refer to the error message text.
The nodes, specified by {1}, are already
part of a 4-fiber BLSR/MS-SPRing type
(specified by {0}).
Refer to the error message text.
Refer to the error message text.
Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
Refer to the error message text.
You can not delete a circuit that is a member
of VCAT circuit.
Refer to the error message text.
Refer to the warning message text.
A monitor circuit does not support Bridge
and Roll.
Refer to the error message text.
The maximum amount of attempts to
unlock this session has been reached.
Refer to the warning message text.
Refer to the warning message text.
The attempt to reconfigure the specified
circuit has failed.
A few circuits could not be created.
The selected item, specified by {0}, is
invalid as per the details, specified in {1}.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-15