Cisco ONS 15454 Troubleshooting Manual page 510

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3145 The RIP metric must be between 1 and 15.
EID-3146 The RIP metric is invalid.
EID-3147 An error occurred while creating the summary address.
EID-3148 No Layer 2 domain has been provisioned.
EID-3149 The MAC addresses could not be retrieved.
EID-3150 The target file {0} is not a normal file.
EID-3151 The target file {0} is not writable.
EID-3152 An error occurred while creating the protection group.
EID-3153 The card cannot be deleted because it is in use.
EID-3154 An error occurred while provisioning the card:
CTC cannot {0} the card.
EID-3155 An error occurred while building the menu.
EID-3156 An error occurred while building the menu.
Cards were not found for the {0} group.
EID-3157 The selected model could not be set because of an unexpected
model class: {0}.
EID-3158 Probable causes:
- Unable to switch, because a similar or higher priority
condition exists on a peer or far-end card.
- A loopback is present on the working port.
1
EID-3159 An error occurred while applying the operation.
EID-3160 An error occurred while provisioning the {0}.
EID-3161 An error occurred while upgrading the ring.
EID-3162 This protection operation cannot be set because the protection
operation on the other side has been changed but not yet
applied.
EID-3163 The data in row {0} cannot be validated.
EID-3164 The new node ID ({0}) for ring ID {1} duplicates the ID of
node {2}.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-22
Chapter 4
Description
The Routing Information Protocol (RIP)
metric should be in the range of 1 to 15.
Refer to the error message text.
There was an error while creating the
summary address.
You must provision any one of the layer 2
domain.
Refer to the error message text.
The specified target file is not a normal file.
The target file is not writeable. Specify
another file.
CTC encountered an error creating
Protection Group.
Refer to the error message text.
CTC cannot perform the task on the card.
CTC encountered an error building the
menu.
CTC encountered an error while building
the menu, as cards could not be found for
the specified group).
CTC encountered an unexpected model
class while trying to complete the task.
Refer to the error message text.
CTC encountered an error while applying
this operation.
CTC encountered the specified error.
An error was encountered while attempting
to upgrade the BLSR. Refer to the details
portion of the error dialog box for more
information.
Refer to the error message text.
CTC cannot validate the data for the
specified row.
The new specified node ID for the specified
ring ID is the same as another node ID.
Error Messages
November 2009