Cisco ONS 15454 Troubleshooting Manual page 111

Chapter 1 General Troubleshooting
i.
j.
k.
Step 4 Confirm that the newly created circuit appears on the Circuits tab list as a two-way circuit.
Note
Create the terminal loopback on the destination port being tested:
Step 5
a.
b.
c.
d.
e.
f.
g.
Complete the
Step 6
Test and Clear the Optical Terminal Loopback Circuit
If the test set is not already sending traffic, send test traffic on the loopback circuit.
Step 1
Examine the test traffic being received by the test set. Look for errors or any other signal information
Step 2
that the test set is capable of indicating.
If the test set indicates a good circuit, no further testing is necessary on the loopback circuit. Clear the
Step 3
terminal loopback from the port:
a.
b.
c.
d.
e.
f.
Clear the terminal loopback circuit:
Step 4
a.
November 2009
In the Circuit Creation destination dialog box, use the same Node, card Slot, Port, and STS (or VT)
used for the source dialog box.
Click Next.
In the Circuit Creation circuit routing preferences dialog box, leave all defaults. Click Finish.
It is normal for the "LPBKTERMINAL (OCN)" condition on page 2-177
loopback setup. The condition clears when you remove the loopback.
Go to the node view of the destination node:
Choose View > Go To Other Node from the menu bar.
•
Choose the node from the drop-down list in the Select Node dialog box and click OK.
•
In node view, double-click the card that requires the loopback.
Click the Maintenance > Loopback > Port tabs.
Select OOS,MT from the Admin State column. If this is a multiport card, select the row appropriate
for the desired port.
Select Terminal from the Loopback Type column. If this is a multiport card, select the row
appropriate for the desired port.
Click Apply.
Click Yes in the confirmation dialog box.
"Test and Clear the Optical Terminal Loopback Circuit" procedure on page
Double-click the intermediate-node card with the terminal loopback.
Click the Maintenance > Loopback > Port tabs.
Select None from the Loopback Type column for the port being tested.
Select the appropriate state (IS; OOS,DSBLD; OOS,MT; IS,AINS) in the Admin State column for
the port being tested.
Click Apply.
Click Yes in the confirmation dialog box.
Click the Circuits tab.
1.4.7 Perform a Terminal Loopback on a Destination-Node Optical Port
Cisco ONS 15454 Troubleshooting Guide, R8.5
to appear during a
1-67.
1-67