Cisco ONS 15454 Troubleshooting Manual page 506

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3055 The soak maintenance pane cannot be created.
EID-3056 Defaults cannot be saved to the file {0}.
EID-3057 Default properties cannot be loaded from the node.
EID-3058 The file {0} does not exist.
EID-3059 An error occurred while refreshing.
EID-3060 The ALS recovery pulse interval must be between {0} seconds
and {1} seconds.
EID-3061 The ALS recovery pulse duration must be between {0} seconds
and {1} seconds.
EID-3062 An error occurred while setting values in the table.
EID-3064 This is not a G1000 card.
EID-3065 An error occurred while attempting to create this RMON
threshold:
{0}
EID-3066 The sample period must be between 10 and {0}.
EID-3067 The rising threshold must be between 1 and {0}.
EID-3068 The falling threshold must be between 1 and {0}.
EID-3069 The rising threshold must be greater than or equal to the falling
threshold.
EID-3070 Error in data for ports {0} Exactly one VLAN must be marked
untagged for each port. These changes will not be applied.
EID-3071 An error occurred while retrieving the learned address list.
EID-3072 An error occurred while clearing the learned address.
EID-3073 An error occurred while clearing the selected rows.
EID-3074 An error occurred while clearing the learned address list by {0}. Error encountered trying to clear the
EID-3075 At least one row in the parameter column must be selected.
EID-3076 CTC lost its connection with this node. The NE Setup Wizard
will exit.
EID-3077 No optical link was selected.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-18
Chapter 4
Description
Refer to the error message text.
CTC cannot save the defaults to the
specified file.
Refer to the error message text.
Refer to the error message text.
There was an error while refreshing.
The automatic laser shutdown (ALS)
Recovery Interval must be between the
specified range of seconds.
The automatic laser shutdown (ALS)
Recovery Duration must be between the
specified range of seconds.
Refer to the error message text.
This card is not a G1000-4 card.
You must wait some time before you try
again.
Refer to the error message text.
This is an invalid rising threshold entry. The
valid range is from 1 to the specified value.
This is an invalid falling threshold entry.
The valid range is from 1 to the specified
value.
Refer to the error message text.
CTC encountered data error for the
specified ports. Only one VLAN should be
marked untagged for each port.
Unable to retrieve the learned MAC address
from the NE.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
learned MAC address from either a VLAN
or a port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Error Messages
November 2009