Cisco ONS 15454 Troubleshooting Manual page 492

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-1044 Warning: there is a discrepancy in the build timestamp between
the NE cached jar file ({0}) and the NE ({1}).
Your CTC jar cache should be emptied.
EID-1046 Selected CTC version ({0}) must be greater than or equal{to
the login NE version ({1}).
EID-2001 No rolls were selected. {0}
EID-2002 The roll must be completed or canceled before it can be deleted. You cannot delete the roll unless it has been
EID-2003 An error occurred while deleting the roll.
{0}
EID-2004 No Cisco IOS slot was selected.
EID-2005 CTC cannot find the online help files for {0}.
The files might have been moved, deleted, or not installed.
To install online help, run the setup program on the software
CD.
EID-2006 An error occurred while editing the circuit(s).
{0}
{1}.
EID-2007 The preferences could not be saved.
EID-2008 The circuit preferences could not be saved:
{0}
EID-2009 CTC was unable to download the package:
{0}
EID-2010 An error occurred while deleting the destination.
EID-2011 The circuit could not be destroyed.
EID-2012 The reverse circuit could not be destroyed.
EID-2013 The circuit creation failed.
The circuit creation cannot proceed due to changes in the
network which affected the circuit(s) being created.
The dialog box will close. Please try again.
EID-2014 No circuit(s) were selected.
{0}
EID-2015 The circuit {0} cannot be deleted because it has one or more
rolls.
EID-2016 The circuit deletion failed.
EID-2017 An error occurred while mapping the circuit.
{0}
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-4
Chapter 4
Description
Refer to the warning message text.
The CTC software version must be greater
than or equal to the software version on the
node being managed.
No rolls were selected for the bridge and
roll.
completed or cancelled.
There was an error when CTC tried to delete
the roll.
You did not select a Cisco IOS slot.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
An error occurred when CTC tried to open
the circuit for editing.
CTC cannot save the preferences.
CTC cannot find the file needed to save the
circuit preferences.
Refer to the error message text.
CTC could not delete the destination.
CTC could not destroy the circuit.
CTC could not reverse the circuit destroy.
Refer to the error message text.
You must select a circuit to complete this
function.
You must delete the rolls in the circuit
before deleting the circuit itself.
CTC could not delete the tunnel as there are
circuits that use the tunnel.
There was an error mapping the circuit.
Error Messages
November 2009