Monitor The Run - GE AKTA avant User Manual

5.9.3

Monitor the run

Introduction
You may follow the on-going method run in the System Control module. The current
system status is shown in the System state panel in the Run Data pane. For example,
it may state Run, Wash or Hold. The same information is also shown in the instrument
display.
•
•
•
For details on the System Control interface, see UNICORN System Control Manual.
Monitor the run
To interrupt a method during a run you may click the Hold, Pause or End buttons in
System Control. A held or paused method run can be resumed by clicking the Continue
button. See the following table.
If you want to...
temporarily hold the method, with current
flow rate and valve positions sustained
temporarily pause the method, and stop all
pumps
resume, for example, a held or paused
method run.
permanently end the run
Note:
ÄKTA avant User Manual 29035184 AE
Selected curves are shown in the Chromatogram pane.
All registered actions during the run are displayed in the Run Log pane.
The current flow path is shown in the Process Picture pane.
When ending a method run in advance, it is possible to save the partial result.
5.9 Create a method and perform a run
5.9.3 Monitor the run
then...
click the button.
click the button.
click the button.
Note:
An ended method cannot be resumed.
click the button.
5 Operation
233