Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 86

Using the CLI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
sdv
snmp-server
span
ssh
switchname
system
tlport
trunk
username
vsan
wwn
xml
zone
zone-attribute-group
zoneset
switch(config)# feature ?
cimserver
cluster
crypto
dpvm
fabric-binding
fcip
fcrxbbcredit
fcsp
ficon
iscsi
ivr
npiv
port-security
port-track
san-ext-tuner
scheduler
sdv
sme
ssh
tacacs+
telnet
switch(config)# feature crypto ?
ike
ipsec
Configuration mode, also known as terminal configuration mode, has several submodes. Each of these
submodes places you deeper in the prompt hierarchy. When you type exit, the switch backs out one level
and returns you to the previous level. When you type end, the switch backs out to the user EXEC level.
You can also type Ctrl-Z in configuration mode as an alternative to typing end.
In configuration mode, you can alternatively enter Ctrl-Z instead of the end command, and Ctrl-G
Note
instead of the exit command.
As of MDS NX-OS Release 4.1(1a), if a command is not available in the current configuration submode,
the command is checked for availability in the higher submodes until the EXEC mode, and then the
command is executed. For example, you can enter the following command without the do keyword.
switch(config)# terminal session-timeout 0
Cisco MDS 9000 Family CLI Configuration Guide
2-8
Config commands for SAN Device Virtualization
Configure snmp server
Enter SPAN configuration mode
Configure SSH parameters
Configure system's network name
System config command
Configure TL Port information
Configure Switch wide trunk protocol
Configure user information.
Enter the vsan configuration mode
Set secondary base MAC addr and range for additional
WWNs
Xml agent
Zone configuration commands
Zone attribute group commands
Zoneset configuration commands
Enable/Disable cimserver
Enable/Disable Cluster
Set crypto settings
Enable/Disable Dynamic Port Vsan Membership
Enable/Disable Fabric Binding
Enable/Disable FCIP
Enable/Disable extended rx b2b credit configuration
Enable/Disable FC-SP
Enable/Disable ficon
Enable/Disable iSCSI
Config commands for IVR
Nx port Id Virtualization (NPIV) feature enable
Enable/Disable port-security
Enable/Disable port track feature
Enable/Disable SAN Extension Tuner Tool
Enable/Disable scheduler
Enable/Disable SAN Device Virtualization
Enable/Disable Storage Media Encryption
Enable/Disable ssh
Enable/Disable tacacs+
Enable/Disable telnet
Enable/Disable IKE
Enable/Disable IPSec
Chapter 2 Before You Begin
OL-18084-01, Cisco MDS NX-OS Release 4.x