Debug Ike - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

debug ike

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug ike
To enable debugging for the IKE protocol, use the debug ike command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
Syntax Description
all
error
event
message
mts
protocol
verbose
warning
Defaults Disabled.
Command Modes
EXEC mode.
Command History Release
2.0(x)
Usage Guidelines To use this command, IKE must be enabled using the crypto ike enable command.
Examples The following example displays the system output when the debug ike all command is issued:
switch# debug ike all
Related Commands Command
no debug all
show crypto ike
domain ipsec
Cisco MDS 9000 Family Command Reference
6-60
debug ike {all | error | event | message | mts | protocol | verbose | warning}
no debug ike {all | error | event | message | mts | protocol | verbose | warning}
Enables all of the debugging flags for IKE.
Enables debugging for IKE errors.
Enables debugging for IKE event generation.
Enables debugging for IKE messages.
Enables debugging for MTS-related IKE activity.
Enables debugging for IKE protocol-related handling.
Enables verbose debugging for IKE protocol-related handling.
Enables debugging for IKE warnings.
Modification
This command was introduced.
Description
Disables all debugging.
Displays IKE protocol information.
Chapter 6 Debug Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x