Chapter 10 H Command; Hash - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

hash

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
hash
To configure a hash algorithm for an IKE protocol policy, use the hash command in IKE policy
configuration submode. To revert to the default, use the no form of the command.
Syntax Description md5
sha
1. MD5 = Message-Digest
2. SHA = Secure Hash Algorithm
Defaults sha.
Command Modes IKE policy configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how to configure the hash algorithm for the IKE protocol:
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)# hash md5
Related Commands Command
crypto ike domain ipsec
crypto ike enable
policy
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
10-2
hash {md5 | sha}
no hash
Specifies the MD5
Specifies the SHA
Modification
This command was introduced.
1
hash algorithm.
2
.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Configures IKE policy parameters.
Chapter 10 H Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x