Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 49

Chapter 1 CLI Overview
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
About the CLI Command Modes
Switches in the Cisco MDS 9000 Family have two main command modeuser EXEC mode and
configuration mode. The commands available to you depend on the mode you are in. To obtain a list of
available commands in either mode, type a question mark (?) at the system prompt.
Table 1-1
system prompts. The system prompt helps you identify which mode you are in and which commands are
available to you.
Table 1-1 Frequently Used Switch Command Modes
Mode Description of Use
EXEC Enables you to temporarily change
terminal settings, perform basic tests, and
display system information.
Note
Configuration Enables you to configure features that
mode affect the system as a whole.
Note
You can abbreviate commands and keywords by entering just enough characters to make the command
unique from other commands. For example, you can abbreviate the config terminal command to conf t.
OL-18089-01, Cisco MDS NX-OS Release 4.x
lists and describes the two commonly used modes, how to enter the modes, and the resulting
Changes made in this mode are
generally not saved across system
resets.
Changes made in this mode are
saved across system resets if you
save your configuration. Refer to
the Cisco MDS 9000 Family CLI
Configuration Guide for further
information.
How to Access
At the switch prompt, enter the required
EXEC mode command.
From EXEC mode, enter the config
terminal command.
Cisco MDS 9000 Family Command Reference
About the CLI Command Modes
Prompt
switch#
switch(config)#
1-3