Channel-Group - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

channel-group

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
channel-group
To add a port to a PortChannel group, use the channel-group command. To remove a port, use the no
form of the command.
Syntax Description port-channel number
force
Defaults
None.
Command Modes Interface configuration mode.
Command History Release
NX-OS 4.1(3)
3.0(1)
Usage Guidelines The auto mode support is not available after 4.x. To convert auto PortChannel to active mode PortChannel,
use the port-channel persistent command. This command needs to be run on both sides of the auto
Port Channel.
Examples
The following example shows how to add a port to the PortChannel:
switch# config terminal
switch(config)# interface fc 1/1
switch(config-if)# channel-group 2 force
fc1/1 added to port-channel 2 and disabled
please do the same operation on the switch at the other end of the port-channel,
then do "no shutdown" at both end to bring them up
switch(config-if)#
Related Commands Command
show interface port-channel
Cisco MDS 9000 Family Command Reference
4-22
channel-group {port-channel number force}
no channel-group {port-channel number force}
Specifies the PortChannel number. The range is 1 to 256.
Specifies the PortChannel to add a port using the force option.
Modification
Deleted auto keyword from the syntax description.
This command was introduced.
Description
Displays the PortChannel interface information.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x