Debug Etherchannel - Cisco WLC 5700 Series Command Reference Manual

debug etherchannel

debug etherchannel

To enable debugging of EtherChannels, use the debug etherchannel command in privileged EXEC mode.
To disable debugging, use the no form of the command.
debug etherchannel [all | detail | error | event | idb ]
no debug etherchannel [all | detail | error | event | idb ]
Syntax Description
all
detail
error
event
idb
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
The undebug etherchannel command is the same as the no debug etherchannel command.
Note Although the linecard keyword is displayed in the command-line help, it is not supported.
When you enable debugging on a stack, it is enabled only on the active controller. To enable debugging on
the standby controller, start a session from the active controller by using the session switch-number command
in privileged EXEC mode. Enter the debug command at the command-line prompt of the standby controller.
To enable debugging on the standby controller without first starting a session on the active controller, use the
remote command switch-number LINE command in privileged EXEC mode.
Examples This example shows how to display all EtherChannel debug messages:
Controller# debug etherchannel all
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
20
(Optional) Displays all EtherChannel debug messages.
(Optional) Displays detailed EtherChannel debug messages.
(Optional) Displays EtherChannel error debug messages.
(Optional) Displays EtherChannel event messages.
(Optional) Displays PAgP interface descriptor block debug messages.
Layer 2/3 Commands
Modification
This command was introduced.
OL-32323-01