Load-Balancing - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 14 L Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

load-balancing

To enable cluster reload balancing for all targets or specific targets, use the load-balancing command.
To disable this command, use the no form of the command.
Syntax Description enable
target wwn
Defaults
None.
Command Modes Cisco SME cluster configuration submode.
Command History Release
3.3(1a)
Usage Guidelines
The reload balancing operation is performed by the Cisco SME administrator for all or specific target
ports. This operation first unbinds all the targets from the Cisco SME interfaces. The targets are then
associated, one at a time, based on the load-balancing algorithm.
The reload balancing operation can be triggered if the targets remain unconnected due to errors in the
prior load balancing opertions in the backend.
Examples
The following example enables reload balancing in Cisco SME:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# load-balancing enable
switch(config-sme-cl-node)#
The following example adds the host to the Cisco SME interface based on the load-balancing policy:
switch# config t
switch(config))# sme cluster c1
switch(config-sme-cl)# load-balancing 17:11:34:44:44:12:14:10
switch(config-sme-cl-node)#
Related Commands Command
show sme cluster
OL-18089-01, Cisco MDS NX-OS Release 4.x
load-balancing {enable | target wwn}
no load-balancing {enable | target wwn}
Enables cluster load balancing.
Specifies the world-wide name (WWN) of the target port.
Modification
This command was introduced.
Description
Displays Cisco SME information.
Cisco MDS 9000 Family Command Reference
load-balancing
14-13