Rscn - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 20 R Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
rscn abort vsan
To cancel a Registered State Change Notification (RSCN) configuration on a VSAN, use the rscn abort
vsan command in configuration mode. To reverse the cancellation, use the no form of the command.
Syntax Description vsan-id
Defaults None.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines None.
Examples The following example cancels an RSCN configuration on VSAN 1.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# rscn abort vsan 1
Related Commands Command
rscn commit vsan
rscn distribute
rscn event-tov
clear rscn session vsan
show rscn
OL-18089-01, Cisco MDS NX-OS Release 4.x
rscn abort vsan vsan-id
no rscn abort vsan vsan-id
Specifies a VSAN where the RSCN configuration should be cancelled. The
ID of the VSAN is from 1 to 4093.
Modification
This command was introduced.
Description
Commits a pending RSCN configuration on a specified VSAN.
Enables the distribution of an RSCN configuration.
Configures an RSCN event timeout.
Clears the RSCN session for a specified VSAN.
Displays RSCN configuration information.
Cisco MDS 9000 Family Command Reference
rscn abort vsan
20-39