Dmm Module Job - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 5 D Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command History Release
NX-OS 4.1(1b)
3.3(1a)
Usage Guidelines DMM must be enabled before you can create DMM jobs. Use the ssm enable feature dmm command
to enable DMM.
The data migration job stops executing if it encounters any errors. To restart the migration, enter the
validate command to validate the job configuration, then enter the restart command to restart the job.
Before creating a storage based data migration job, use the show dmm module vi-list command to
choose the VI for migrating the data and then use the set-vi command to specify the VI.
Examples
The following example shows how to create a job with a schedule. The job is scheduled to start on
Sunday, January 6, 2008 at 11:00 P.M.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# dmm module 3 job 1 schedule hour 23 min 0 day 6 month 1 year 2008
Command
show dmm job
show dmm module vi-list Displays the list of VIs.
show dmm ip-peer
OL-18089-01, Cisco NX-OS Release 4.x
Modification
The set-vi and modify rate keywords were introduced.
The finish keyword is introduced.
Description
Displays DMM job information.
Displays the IP peers that the DMM port is connected to.
Cisco MDS 9000 Family Command Reference

dmm module job

5-41