Dpvm Database - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 5 D Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

dpvm database

To activate and configure the dynamic port VSAN membership (DPVM) database, use the dpvm
database command. To deactivate the database, use the no form of the command.
Syntax Description This command has no other arguments or keywords.
Defaults
Deactivated.
Command Modes
Configuration mode.
Command History Release
2.0(x)
Usage Guidelines To use this command, DPVM must be enabled using the dpvm enable command.
The DPVM database consists of a series of device mapping entries. Each entry consists of device pWWN
or nWWN along with the dynamic VSAN to be assigned. Use the nwwn command or pwwn command
to add the entries to the DPVM database. This database is global to the whole switch (and fabric) and is
not maintained for each VSAN.
Examples
The following example shows how to activate the DPVM database and enter DPVM database
configuration submode:
switch# config terminal
switch(config)# dpvm database
switch#(config-dpvm-db)#
The following example shows how to activate the DPVM database and enter nWWN device:
switch#(config-dpvm-db)# nwwn 14:21:30:12:63:39:72:81 vsan 101
Successful. Commit should follow for command to take effect.
excal-178(config-dpvm-db)#
The following example shows how to activate the DPVM database and enter pWWN device:
switch#(config-dpvm-db)# pwwn 14:21:30:12:63:39:72:81 vsan 101
Successful. Commit should follow for command to take effect.
switch#(config-dpvm-db)#
OL-18089-01, Cisco NX-OS Release 4.x
dpvm database
no dpvm database
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
dpvm database
5-49