Clear Ips Arp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

clear ips arp

To clear ARP caches, use the clear ips arp command in EXEC mode.
Syntax Description
address
ip-address
interface
gigabitethernet
module-number
Defaults None.
Command Modes EXEC.
Command History Release
1.1(1)
Examples The ARP cache can be cleared in two ways: clearing just one entry or clearing all entries in the ARP
cache.
The following example clears one ARP cache entry:
switch# clear ips arp address 10.2.2.2 interface gigabitethernet 8/7
arp clear successful
The following example clears all ARP cache entries:
switch# clear ips arp interface gigabitethernet 8/7
arp clear successful
OL-18089-01, Cisco MDS NX-OS Release 4.x
clear ips arp {address ip-address | interface gigabitethernet module-number}
Clears fcflow aggregated statistics.
Enters the peer IP address.
Specifies the Gigabit Ethernet interface.
Specifies the slot and port of the Gigabit Ethernet interface.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
clear ips arp
4-57