cluster
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
cluster
To configure a cluster feature, use the cluster command.
Syntax Description
enable
Defaults
None.
Command Modes
Configuration mode.
Command History
Release
3.2(2)
NX-OS 4.1(1c)
Usage Guidelines
Starting from Cisco NX-OS 4.x release, the cluster command is replaced by the feature command.
Examples
The following example enables the Cisco SME clustering:
switch# config terminal
switch(config)# cluster enable
switch(config)#
Cisco MDS 9000 Family Command Reference
4-110
cluster enable
Modification
This command was introduced.
Cluster command is replaced by the feature command.
Enables or disables a cluster.
Chapter 4
C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x