Islb Save-Initiator - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

islb save-initiator

To permanently save the automatically-assigned nWWN/pWWN mapping for the iSLB initiator, use the
islb save-initiator command.
Syntax Description ip-address ip-address
name name
Defaults None.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines Saving the automatically assigned nWWN/pWWN mapping allows the initiator to use the same mapping
the next time it logs in.
You can convert a dynamic iSLB initiator to a static iSLB initiator and make its WWNs persistent.
You cannot convert a dynamic iSCSI initiator to a static iSLB initiator or a dynamic iSLB initiator to a
Note
static iSCSI initiator.
Note Making the dynamic mapping for iSLB initiators static is the same as for iSCSI.
Only a statically mapped iSLB initiator configuration is distributed throughout the fabric using CFS.
Note
Dynamically and statically configured iSCSI initiator configurations are not distributed.
Examples The following example saves the nWWNs and pWWNs that have automatically been assigned to the
iSLB initiator whose name is specified.
switch# config t
switch(config)# islb save-initiator name iqn.1987-02.com.cisco.initiator
The following example saves the nWWNs and pWWNs that have automatically been assigned to the
iSLB initiator whose IPv4 address is specified.
switch(config)# islb save-initiator ip-address 10.10.100.11
OL-18089-01, Cisco MDS NX-OS Release 4.x
islb save-initiator [ip-address ip-address | name name]
Specifies the initiator IP address. The format is A.B.C.D or X:X:X::X.
Specifies the initiator name to be used from 1 to 223 characters.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
islb save-initiator
11-107