Dmm Module Job - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

dmm module job

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
dmm module job
To configure a data migration job, use the dmm module mod-id job command in configuration mode.
Syntax Description module mod-id
job job-id
create
destroy
finish
get-vi
vsan vsan-id
modify
rate
schedule
hour hour
min minute
day day
month month
year year
session
now
reset
set-vi
portwwn
nodewwn
vsan vsan-id
start
stop
validate
verify
Defaults None.
Command Modes
Configuration mode.
Cisco MDS 9000 Family Command Reference
5-40
dmm module mod-id job job-id {create | destroy | finish | get-vi vsan vsan-id | modify rate |
schedule {{hour hour min minute day day month month year year | now |reset}} | session |
set-vi portwwn nodewwn vsan vsan-id | start | stop | validate | verify}
Specifies the module ID.
Specifies the job ID. The range is 0 to18446744073709551615.
Creates the job and enters DMM job configuration submode.
Deletes the DMM job.
Moves the Method 2 data migration job to completed state.
Retrieves the virtual initiator (VI) for the DMM job.
Specifies the VSAN ID. The range is 1 to 4093.
Modifies the DMM job attributes.
Specifies the rate of the job attribute. The range is from 1 to 4. Specify 1 for
a default value, 2 for slow, 3 for medium and 4 for fast rates.
Schedules the DMM job.
Specifies the hour the DMM job starts. The range is 0 to 23.
Specifies the minute the DMM job starts. The range is 0 to 59.
Specifies the day the DMM job starts. The range is 1 to 31.
Specifies the month the DMM job starts. The range is 1 to 12.
Specifies the year the DMM job starts. The range is 2000 to 2030.
Enables the Session Configuration submode.
Resets the schedule to start the DMM job immediately.
Resets the DMM job to unscheduled.
Sets the VI for the storage based job.
Specifies the port WWN. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
Specifies the node WWN. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
Specifies the VSAN ID. The range is 1 to 4093.
Starts the DMM job session.
Stops the DMM job.
Validates the DMM job data.
Verifies the data migration for the specified job.
Chapter 5 D Commands
OL-18089-01, Cisco NX-OS Release 4.x