Peer (Dmm Job Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

peer (DMM job configuration submode)

To add peer SSM information to a job, use the peer command in DMM job configuration submode. To
remove the peer SSM information from a job, use the no form of the command.
Syntax Description ip-address
Defaults
None.
Command Modes DMM job configuration submode.
Command History Release
3.2(1)
Usage Guidelines
In a dual-fabric topology, the migration job runs on an SSM in each fabric. The two SSMs exchange
messages over the management IP network, so each SSM needs the IP address of the peer.
Examples The following example shows how to add peer SSM information to a job:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# dmm module 3 job 1 create
Started New DMM Job Configuration.
Do not exit sub-mode until configuration is complete and committed
switch(config-dmm-job)# peer 224.2.1.2
switch(config-dmm-job)#
Related Commands Command
show dmm job
show dmm ip-peer
OL-18089-01, Cisco MDS NX-OS Release 4.x
peer ip-address
no peer ip-address
Specifies the peer SSM IP address. The format for the IP address is A.B.C.D.
Modification
This command was introduced.
Description
Displays job information.
Displays the IP peer of a DMM port.
peer (DMM job configuration submode)
Cisco MDS 9000 Family Command Reference
18-3