Action Policy-Default - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 2 A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

action policy-default

To enable the default action(s) of the policy being overridden, use the action policy-default command.
Syntax Description
number. number2
Defaults None.
Command Modes
Embedded Event Manager mode.
Command History Release
NX-OS 4.1(3)
Usage Guidelines None.
Examples The following example shows how to enable the default action of a policy being overridden when an
EEM applet is triggered:
switch# configure terminal
switch(config)# event manager applet default-applet
switch(config-applet)# action 1.0 policy-default
switch(config-applet)#
Related Commands Command
event manager applet
OL-18089-02, Cisco MDS NX-OS Release 4.x
action number [.number2] policy-default
Number can be any number up to 16 digits. The range for number2 is from
0 to 9.
Modification
This command was introduced.
Description
Displays an applet with the Embedded Event Manager.
Cisco MDS 9000 Family Command Reference
action policy-default
2-19