Flex-Attach Virtual-Pwwn - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

flex-attach virtual-pwwn

To map the real port WWN (pWWN) and a user-specific virtual pWWN, use the flex-attach
virtual-pwwn command. To disable the mapping, use the no form of the command.
Syntax Description vpwwn
pwwn pwwn
Defaults
None.
Command Modes
Configuration mode
Command History Release
3.3(1a)
Usage Guidelines None.
Examples
The following example shows how to map the real pWWN and a user-specific virtual pWWN on an
interface.
switch# config
Enter configuration commands, one per line.
switch# (config) flex-attach virtual-pwwn 20:04:00:a0:b8:16:92:18 pwwn
21:03:00:a0:b9:16:92:16
Related Commands Command
flex-attach
virtual-pwwn auto
flex-attach
virtual-pwwn
interface
OL-18089-01, Cisco MDS NX-OS Release 4.x
flex-attach virtual-pwwn vpwwn pwwn pwwn
no flex-attach virtual-pwwn vpwwn pwwn pwwn
Specifies the virtual pWWN chosen by the user.
Specifies the pWWN to be mapped to the user-specific virtual pWWN.
Note
Modification
This command was introduced.
Description
Enables the FlexAttach virtual pWWN on a specific interface.
Sets the user-specific FlexAttach virtual pWWN.
pWWN must not be logged in.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
flex-attach virtual-pwwn
8-77