Fspf Hello-Interval - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fspf hello-interval

To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use
the no form of the command.
Syntax Description hello-interval seconds
vsan vsan-id
Defaults
20 seconds.
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines
Access this command from the
This command configures FSPF for the specified FCIP interface.
This value must be the same in the ports at both ends of the ISL.
Note
Examples The following example configures a hello interval of 3 seconds on VSAN 1.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf hello-interval 3 vsan 1
Related Commands Command
show fspf interface
show interface fcip
OL-18089-01, Cisco MDS NX-OS Release 4.x
fspf hello-interval seconds vsan vsan-id
no fspf hello-interval seconds vsan vsan-id
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified FCIP interface.
Specifies the FSPF hello-interval in seconds. The rage is 1 to 65534.
Specifies a VSAN ID. The range is 1 to 4093.
submode.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
fspf hello-interval
8-87