Debug Fc2 - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

debug fc2

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
loopback
pkt
both
tx
rx
bytes bytes
pkts pkts
pkthdr
rdl
rxhdrhistory
txhdrhistory
Defaults
Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines If FSPF receives a bad FC2 packet analyze the output of the debug fc2 pkt command.
Examples The following example displays the system output when the debug fc2 error vsan 1 command is issued:
switch1# debug fc2 error vsan 1
Related Commands Command
no debug all
show fc2
Cisco MDS 9000 Family Command Reference
6-34
Enables FC2 loopback debugging.
Enables FC packet debugging.
Enables debugging in both the transmit and receive directions.
Enables debugging in the transmit direction,
Enables debugging in the receive direction.
Specifies the number of bytes to display.
Specifies the number of packets to display.
Enables FC header debugging.
Enables FC2 RDL debugging.
Enables FC2 received header history debugging.
Enables FC2 transmitted header history debugging.
Modification
This command was introduced.
Description
Disables all debugging.
Displays FC2 information.
Chapter 6 Debug Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x