Rebooting The Thor Vm2; Tapping The Touch Screen With A Stylus - Honeywell Thor VM2 User Manual

Press the power button to turn the Thor VM2 on. When the Windows desktop is dis-
played or an application begins, the power up sequence is complete.
After initial power on, the Thor VM2 can be configured to automatically power on. See
Power Controls

Rebooting the Thor VM2

If a USB drive, such as a thumb drive is attached to the Thor VM2, the device
attempts to boot from the USB drive:
•
•
Restart
Restart performs a controlled shutdown of the Thor VM2 and then restarts the device.
•
•
•

Tapping the Touch Screen with a Stylus

Note: Always use the point of the stylus for tapping or making strokes on the touch screen.
Never use an actual pen, pencil, or sharp/abrasive object to write on the touch
screen.
Hold the stylus as if it were a pen or pencil. Touch an element on the screen with the tip
of the stylus then remove the stylus from the screen.
Firmly press the stylus into the stylus holder when the stylus is not in use.
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
for more information.
If the USB drive contains a bootable sector, the Thor VM2 boots from the USB drive.
If the USB drive does not contain a bootable sector, the Thor VM2 does not boot.
Remove the USB drive and boot the Thor VM2 again.
If an optional keyboard is attached, use the Ctrl + Alt + Del keypress sequence to start
the task manager. Tap the Shut Down button and select Restart from the pull-down
list. Tap the OK button to restart the Thor VM2.
Select Start > Shut Down > Restart and tap OK to restart the Thor VM2.
Use the P1 + P5 + Orange key press sequence to reboot the Thor VM2. The keys must
be pressed in sequence; they do not need to be held down simultaneously.
19