GE B30 Communications Manual page 455

CHAPTER 3: IEC 61850 COMMUNICATION
Data object CDC Semantics
name
TagOn SPS Breaker tagged.
The BREAKER 1 TAG ON operand.
TagOff SPS Breaker not tagged.
The BREAKER 1 TAG OFF operand.
TapLocFlt SPS L90 - The fault is identified between the local terminal and the tap point.
The TAP-LOCAL FAULT operand.
TdrTrbl SPS TDR trouble.
The TDR TROUBLE operand.
TempMnt SPS The ambient temperature is greater than the maximum operating temperature.
The TEMP MONITOR operand.
TestMod SPS LED indication - Relay in Test Mode.
The LED TEST MODE operand.
TestPrgInd SPS LED indication - Test In-Progress.
The LED TEST IN PROGRESS operand.
ThmCap MV % thermal model motor unbalance.
MOTOR THERMAL CAPACITY USED in percentage (%).
ThmLOTm MV Indicates Thermal Lockout for the motor.
THERMAL LOCKOUT TIME in seconds.
ThrdEthFail SPS Third Ethernet failure.
The THIRD ETHERNET FAIL operand.
TmChgOp1 SPS Change in round trip delay on the channel exceeded pre-set value.
87L DIFF CH 1 TIME CHNG operand, which becomes On when the Change in round
trip delay on channel 1 exceeded preset value.
TmnsDelta MV PTP-IRIG-B Delta in ns
TmOfClc INS Represents the UTC time of the broken rotor bar calculation in seconds elapsed
since 1970/01/01, 00.00.00.
The TIME OF BRB CALC. actual value.
TmOfMax INS The TIME OF MAXIMUM BRB actual value
TmStr1 SPS Power swing timer picked up.
The POWER SWING TMR2 PKP operand.
ToOilTmp MV Indicates top oil temperature.
The TOP OIL degrees C actual value.
TotLOTm MV Indicates total lockout time for the motor. TOTAL MOTOR LOCKOUT TIME in
seconds.
Tr1p ACT Single pole trip operation initiated.
The 87L TRIP 1P OP operand.
General is TRIP 1-POLE operand, phsA is TRIP PHASE A operand, phsB is TRIP
PHASE B operand, and phsC is TRIP PHASE C operand.
Tr3p ACT Three pole trip operation initiated.
The DCUB TRIP 3P operand.
The DIR BLOCK1 TRIP 3P operand.
The DUTT TRIP 3P operand.
The HYBRID POTT TRIP 3P operand.
The 87L TRIP 3P OP operand.
The POTT1 TRIP 3P operand.
The PUTT TRIP 3P operand.
The TRIP 3-POLE operand.
Tr3pFrcd SPS Three pole trip mode is being forced.
The TRIP FORCE 3-POLE operand (3-pole trip mode is being forced).
TransBlk SPS Phase comparison transient blocking has operated.
The 87PC TRANS BLOCK OP operand.
TrcHz MV B90 frequency
Trigger11 ENS Represents the Hi-Z Data Capture 1 trigger type
Trigger21 ENS Represents the Hi-Z Data Capture 1 RMS type
TripInd SPS LED indication - Element Trip Indication.
The LED TRIP operand.
UR FAMILY – COMMUNICATIONS GUIDE
MODEL IMPLEMENTATION CONFORMANCE STATEMENT (MICS)
Used in logical nodes...
Bkr0XCBR
Bkr0XCBR
FltRptRFLO
LPHD
LPHD
LEDsIHMI
LEDsIHMI
MotThmPTTR
MotThmPTTR
LPHD
LinDfPDIF
TmClkLTMS
BknRotSVBR
BknRotSVBR
PwrSwgRPSB
HPTmpSPTR
MotThmPTTR
LinDfPDIF, TrOutPTRC
DCB_PSCH, DCB1_PSCH,
DCUB_PSCH, DUTT_PSCH,
HPOTT_PSCH, LinDfPDIF,
POTT_PSCH, POTT1_PSCH,
PUTT_PSCH, TrOutPTRC
TrOutPTRC
PhCmp1PDIF
B_FrqMMXN
HiZPHIZ
HiZPHIZ
LEDsIHMI
3-217
3