Tightening Torque Specifications; Special Tools And Equipment; Use Of Special Tools - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

Tightening Torque Specifications

Fastening part
SDM bolt
Driver air bag (inflator) module mounting bolt
Passenger air bag (inflator) module attaching
bolt
Sleeve lock nut
Side curtain-air bag (inflator) module bolts
Forward-sensor mounting bolt
Side-sensor bolt
NOTE
The specified tightening torque is also described in the following.
"Air Bag System Components, Wiring and Connectors Location"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information in Section 0A".

Use of Special Tools

WARNING
!
To avoid deployment when troubleshooting
the air bag system, do not use electrical test
equipment such as a battery powered or AC
powered voltmeter, ohmmeter, etc., or any
type of electrical equipment other than that
specified. Do not use a non-powered probe
type tester.
Instructions must be followed carefully,
otherwise personal injury may result.
You should be familiar with the tools listed under the
heading "Special Tool". You should be able to measure
voltage and resistance. You should be familiar with
proper use of a scan tool such as Air Bag Driver /
Passenger Load Tool, Connector Test Adapter Kit and
the Digital Multimeter.
Special tool
(A): 09932–76010 (Connector Test Adapter Kit)
This must be used whenever a diagnostic procedure
requests checking or probing a terminal.
Using the appropriate adapter in the special tool will
ensure that no damage to the terminal will occur from the
multimeter probe, such as spreading or bending.
Specifications
N⋅m
6
9
23
2.5
10
11
11

Special Tools and Equipment

S6JB0A8208001
The adapter (1) will also give an idea of whether or not
contact tension is sufficient, helping to find an open or
intermittent open due to poor terminal contact. An SDM
short bar release tool (2) is included in the connector test
adapter kit. Inserting it into the SDM connector (3) will
releases the shorting bar.
Tightening torque
kgf-m
lb-ft
0.6
4.5
0.9
6.5
2.3
16.5
0.25
2.0
1.0
7.5
1.1
8.0
1.1
8.0
3
Air Bag System:
8B-122
S6JB0A8207001
Note
I5JB0A820107-01
1
2
I5JB0A820108-01

Advertisement

Table of Contents
loading

Table of Contents